FSFabShopSource

Fabrication guides

Straight answers for running a fab shop: pricing, cutting, layout and material.

How to Quote Dumpster Enclosure Gates

A step-by-step way to price steel dumpster enclosure gates: frame and skin material, hinges, drop rods and latches, coating, labor hours and markup on a quote.

Read

Powder Coat vs Paint vs Hot-Dip Galvanizing

How powder coating, paint and hot-dip galvanizing compare for steel fabrications: protection, prep, part size, repairs, lead time and what to tell the customer.

Read

Stainless Steel Tube Weight per Foot and per Metre

How to calculate 304 and 316 stainless steel tube weight in lb/ft and kg/m, with a chart for common square and round sizes, formulas and a 32x32x2 mm example.

Read

Steel Plate Weight per Square Foot by Thickness

Steel plate weighs about 40.8 lb per square foot per inch of thickness. Chart for 3/16" to 1" plate, full-sheet weights, the formula and stainless and aluminum.

Read

Flat Bar Sizes and Weights: A Quick Chart for Steel Flat Bar

Steel flat bar sizes and weight per foot in one chart, plus the formula to work out any size, how to read callouts, and how to estimate weight for a cut list.

Read

How to Write a Fabrication Shop Quote

A step-by-step way to write a metal fabrication quote: scope, material takeoff, labor hours, markup, exclusions and terms, so every job is priced the same.

Read

Angle Iron Sizes and Weights Chart

Angle iron sizes and weight per foot for common equal and unequal leg steel angles, how sizes are written, and a quick formula to calculate any angle weight.

Read

Steel Pipe Schedule Chart: Schedule 40 and 80

Schedule 40 and 80 steel pipe chart from 1/2 to 8 in: outside diameter, wall thickness, inside diameter and weight per foot, plus how pipe sizing works.

Read

How to calculate miter cuts on tube, angle and flat bar

Miter cut math for metal fabrication: miter angle for any corner or frame, long point vs short point, the depth x tan rule, saw settings and how to nest mitered parts.

Read

Markup vs margin: how to price a metal fabrication job

How fab shops build a quote: cost of goods, markup on materials, labor at a shop rate, and why markup is not the same as margin. With a markup to margin table.

Read

How to calculate your fab shop's hourly rate

A step-by-step method for setting a fabrication shop rate: yearly costs, billable hours, profit, and a worked example you can run with your own numbers.

Read

How to reduce steel drop on your cut lists

Practical ways to waste less tube, angle and bar: nesting cuts, choosing 20 vs 24 foot stock, accounting for kerf and trim, sharing miter cuts and keeping usable drops.

Read

Bolt hole edge distance and spacing for steel plates

Minimum edge distance and bolt spacing for base plates, tabs and gussets, with standard hole sizes and a quick reference table from the AISC Specification.

Read

Sheet metal gauge to inches chart for steel

Steel sheet and tube gauge to decimal inch chart with weight per square foot, plus how tube wall gauges differ from sheet gauges.

Read

How to estimate steel for a fabrication job

A step-by-step way to take off steel for a fab job: build the cut list, nest it into sticks, price by the stick or by the pound, and add plate, finish and hardware.

Read

Choosing square tube size and wall thickness

A practical guide to common square tube sizes and walls for gates, railings, frames and posts, with weights and what each wall is typically used for.

Read

Cold saw vs bandsaw vs abrasive chop saw for steel

Which saw to use for cutting steel tube, angle and bar in a fab shop: cut quality, speed, kerf, miter capability and cost per cut for cold saws, bandsaws and abrasive chop saws.

Read