FSFabShopSource

Cold saw vs bandsaw vs abrasive chop saw for steel

Which saw to use for cutting steel tube, angle and bar in a fab shop: cut quality, speed, kerf, miter capability and cost per cut for cold saws, bandsaws and abrasive chop saws.

Most fab shops end up with more than one saw. Each type has a job it does best. Here is how they compare for cutting carbon steel tube, angle, channel and bar.

Abrasive chop saw

A 14" abrasive wheel grinds through the material. It is cheap to buy and cuts almost anything, but it is slow, loud, throws sparks and grit, leaves a heavy burr and a hot, discolored end, and the wheel wears smaller as you go. Kerf is about 1/8". Good for the occasional cut, field work and hardened material. Not good for accurate miters or high volume.

Cold saw

A slow-turning toothed blade (high speed steel or carbide) chips the metal off. Cuts are fast, square, nearly burr-free and cool enough to handle right away. Most cold saws swing for miters, often to 45° both ways, and hold angles accurately. Kerf is usually around 1/16" to 1/8" depending on the blade. The trade-offs are higher machine and blade cost, limited capacity per cut, and blades that chip if you feed too hard or cut the wrong wall thickness for the tooth count.

Horizontal or vertical bandsaw

A continuous bimetal blade cuts slowly but steadily, with coolant on production machines. Bandsaws handle large sections and bundles, can run unattended through a cut, and have the thinnest kerf (often around 1/16"). Miter capability depends on the machine: many horizontal saws swing to 45° or 60°. Cuts are a little less square than a good cold saw unless the saw is well tuned and the blade is sharp.

Quick comparison

SawSpeedFinishTypical kerf
Abrasive chop sawSlowBurr, heat~1/8"
Cold sawFastClean, square~1/16"–1/8"
BandsawModerateClean~1/16"

Kerf matters for your cut list

Every cut removes the blade width. On a 20' stick with 12 cuts, the difference between 1/16" and 1/8" kerf is 3/4" of material. Enter your real kerf in the cut list optimizer so the last piece on a full stick isn't short. For mitered parts, see how to calculate miter cuts and the miter cut calculator.

Frequently asked questions

What is the kerf of a cold saw blade?

Typically about 1/16 to 1/8 inch, depending on blade diameter and type. Check the width printed on the blade.

Is a cold saw better than an abrasive chop saw for steel?

For accuracy, speed and finish, yes. A cold saw leaves a clean, square, nearly burr-free cut that is cool to the touch. An abrasive saw is cheaper and more versatile but slower, hotter and rougher.

More guides