FSFabShopSource

How to reduce steel drop on your cut lists

Practical ways to waste less tube, angle and bar: nesting cuts, choosing 20 vs 24 foot stock, accounting for kerf and trim, sharing miter cuts and keeping usable drops.

Drop is the piece left over after the last cut on a stick. A few inches is fine. A pile of 3-foot offcuts that never get used is money you paid for and then scrapped.

1. Nest the whole list, not one size at a time

Cutting all of one length, then the next, leaves a drop on nearly every stick. Mixing lengths so each stick is filled as completely as possible usually saves 5 to 15% of material on a typical job. That is what the cut list optimizer does: it packs each stick with the best combination of remaining pieces, then tries thousands of re-packs to save another stick.

2. Account for kerf and trim

Every cut removes material. A cold saw or bandsaw blade takes about 1/16" to 1/8". An abrasive chop saw about 1/8". On a stick with 12 cuts that is up to 1-1/2". Mill ends are rarely square, so trim 1/4" to 1/2" off the first end. If you plan with zero kerf, the last piece on a full stick comes up short.

3. Compare 20', 24' and 40' stock

The best stock length depends on your cut lengths. Five 57" pieces don't fit on a 20' stick (240") with kerf and trim, but just fit on 24' (288"). Ask your supplier what lengths they stock, then compare. The optimizer shows the stick count and yield for 20', 24' and 40' automatically.

4. Share miter cuts

Mitered parts with the same angle can be placed end to end so one cut makes both ends. Each shared cut saves the long-point-to-short-point offset: 2" per cut on 2" tube at 45°. Pro nests mitered parts this way. See how to calculate miter cuts.

5. Keep a drop rack with a rule

Pick a minimum length worth keeping (for example 24") and scrap anything shorter right away. Label drops with size and length so they actually get used. Before ordering, check the rack and enter usable drops as custom stock lengths.

Frequently asked questions

What kerf should I use for a cold saw?

About 1/16 to 1/8 inch. Check the blade width printed on the blade, and use 1/8 inch when in doubt.

Is 20 foot or 24 foot steel stock better?

It depends on the cut lengths. Run the cut list for both: sometimes 24 foot stock saves a whole stick and sometimes it adds drop.

More guides