Every miter comes down to three numbers: the miter angle, the depth of the material in the direction of the cut, and whether your length is measured at the long point or the short point. Get those right and the frame closes up square every time.
1. Find the miter angle
- Two pieces meeting at a corner: miter = (180 − corner angle) ÷ 2. A 90° corner is 45° on each piece. A 120° corner is 30°. A 135° corner is 22.5°.
- A closed frame with N equal sides: miter = 180 ÷ N on both ends of every piece. Square or rectangle: 45°. Hexagon: 30°. Octagon: 22.5°.
- A brace or rail meeting a post at an angle: the miter is the angle the brace makes away from square to the post. A 30° rake on a handrail is a 30° miter at each post.
Most cold saws, bandsaws and chop saws read 0° at a square cut, so you set the saw to the miter angle directly. If your saw reads 90° at square, set it to 90 minus the miter angle.
2. Long point to short point
The long point is the tip of the cut on the long face. The short point is where the cut meets the opposite face. The distance between them, measured along the length, is:
offset per end = depth × tan(miter angle)
Depth is the material size in the direction the cut travels. Mitering 2x2 tube across a 2" face at 45°: tan 45° = 1, so the offset is exactly 2". Mitering 3x2 rectangular tube across the 3" face at 30°: 3 × 0.577 = 1.732", about 1-3/4".
So a 36" long-point piece with 45° miters on both ends of 2" tube is 36 − 2 − 2 = 32" at the short point. If the drawing gives inside (short point) dimensions, add the offsets instead.
3. Frames: outside or inside dimensions
For a rectangular frame with 45° corners, each piece measured at the long point equals the outside dimension of the frame. Measured at the short point it equals the inside dimension. That means a 24" x 36" outside frame in 2" tube is cut 24" and 36" long point, which is 20" and 32" short point.
4. Mark and cut
- Square the first end of the stick, then cut the first miter with the long point at your mark.
- Hook your tape on the long point and mark the next long point, or mark the short point using the offset.
- Flip the stick (rotate it 180° about its length) for a frame piece so both long points land on the same face.
5. Save material by sharing cuts
When two mitered pieces with the same angle sit next to each other on a stick, one saw cut can make both ends. Each shared cut saves the full long-point-to-short-point offset, which on 2" tube at 45° is 2" of material per cut. On a list of 40 frame pieces that adds up to a stick or more.
Use the miter cut calculator for the numbers, and the cut list optimizer with Pro to nest mitered parts and get a cut order that tells your saw operator which way to flip each piece.
Frequently asked questions
What is the formula for a miter cut offset?
Offset per end = material depth x tan(miter angle). At 45 degrees the offset equals the depth.
How do I find the miter angle for a hexagon frame?
Divide 180 by the number of sides. A hexagon is 180 / 6 = 30 degrees on each end of every piece.